13
Troubleshooting
If the browser does not display the web page:
• Restore the WNDR4500 router to factory default settings. Use a
paper clip to press the Reset button for 5 seconds. Release the
button when you see that the Power LED is blinking amber. The
router reboots immediately.
• Make sure that the computer is connected to one of the four LAN
Ethernet ports or wirelessly connected to the router.
• Make sure that the router has full power, the Power LED is solid
green, and the Ethernet LED is either solid amber or solid green.
• Close and reopen the browser to make sure that the browser
does not cache the previous page.
• Type http://www.routerlogin.net.
• If the computer is set to a static or fixed IP address (this setting is
uncommon), change it to obtain an IP address automatically from
the router.
ReadySHARE Access
After installation and setup, you can insert a USB storage device into
the USB port on the router
and share the contents with other network
users. (If your USB device has special drivers, it is not compatible.)
To Next Page
Loading...
