EasyManuals Logo

NETGEAR Nighthawk AX4 User Manual

NETGEAR Nighthawk AX4
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
With a 6rd tunnel configuration, the router follows the RFC5969 standard, supporting
two ways to establish a 6rd tunnel IPv6 WAN connection:
Auto Detect mode. In IPv6 Auto Detect mode, when the router receives option 212
from the DHCPv4 option, autodetect selects the IPv6 as 6rd tunnel setting. The router
uses the 6rd option information to establish the 6rd connection.
Manual mode. Select 6rd Tunnel. If the router receives option 212, the fields are
automatically completed. Otherwise, you must enter the 6rd settings.
To set up an IPv6 6rd Internet connection:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select 6rd.
The page adjusts.
The router automatically detects the information in the following sections:
6rd (IPv6 Rapid Development) Configuration. The router detects the service
provider’s IPv4 network and attempts to establish an IPv6 6rd tunnel connection.
If the IPv4 network returns 6rd parameters to the router, the page adjusts to display
the correct settings in this section.
Router’s IPv6 Address on LAN. This field shows the IPv6 address that is acquired
for the router’s LAN interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6. Select an IPv6 Domain Name Server (DNS) Address radio button:
Get Automatically from ISP. Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address.
Use These DNS Servers. If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP’s primary DNS server. If a secondary
DNS server address is available, enter it also.
User Manual36Specify Your Internet Settings
Nighthawk AX4 4-Stream AX3000 WiFi Router

Table of Contents

Other manuals for NETGEAR Nighthawk AX4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR Nighthawk AX4 and is the answer not in the manual?

NETGEAR Nighthawk AX4 Specifications

General IconGeneral
WiFi PerformanceAX3000 (600 + 2400 Mbps)
WiFi RangeMedium to large homes
ProcessorDual-core processor
USB Ports1 x USB 3.0
Number of Antennas4
BeamformingYes
MU-MIMOYes
OFDMAYes
WiFi Technology802.11ax
Ethernet Ports4 LAN) Gigabit Ethernet ports
SecurityWPA3
Memory256MB RAM and 128MB Flash

Related product manuals