NETGEAR Nighthawk X6 R8000

Hardware Setup
10
Nighthawk X6 AC3200 Tri-Band WiFi Router
Top View
The router has status LEDs and buttons on the top.
LEDs
Figure 2. Router LEDs and buttons
Table 1. LED and button descriptions
LED Description
Power
• Solid amber. The router is starting.
• Blinking amber. The
firmware is upgrading, or the Reset button was pressed.
• Solid white. The
router is ready.
• Blinking white. The
firmware is corrupted.
• Off. Power is not supplied to the router.
Internet
• Solid white. The Internet connection is ready.
• Solid amber.
The router has detected an Ethernet cable connection to the modem.
• Off. No Ethernet cable is connected between the router and the modem.
2.4 GHz
Wireless
• Solid white. The 2.4 GHz WiFi radio is operating.
• Blinking. The
router is sending or receiving WiFi traffic.
• Off.
The 2.4 GHz WiFi radio is off.
5 GHz WiFi 1
• Solid white. The 5 GHz-1 WiFi radio is operating.
• Blinking. The
router is sending or receiving WiFi traffic.
• Off. The
5 GHz-1 WiFi radio is off.
5 GHz WiFi 2
• Solid white. The 5 GHz-2 WiFi radio is operating.
• Blinking. The
router is sending or receiving WiFi traffic.
• Off. The
5 GHz-2 WiFi radio is off.