Table 2. Orbi satellite LED descriptions
LED BehaviorLED
The Power LED is located above the Power On/Off button on the rear panel.
•
Solid green. Power is on.
•
Solid amber. The satellite is booting.
•
Blinking amber. The satellite is resetting to factory default settings.
•
Blinking red. The firmware is corrupted.
•
Off. Power is not supplied.
Power
LED
The ring LED is located on the top.
•
White. The satellite is attempting to sync with the router.
•
Blue. The router and satellite successfully synced, and the connection is good.
•
Amber. The router and satellite successfully synced, and the connection between the router and
satellite is fair. Consider moving the satellite closer to the router.
•
Magenta.
The router and satellite failed to sync. Move the satellite closer to the router and try again.
•
Off. The satellite synced to the router and is working normally.
Ring LED
Labels
The router label shows the admin login information, WiFi network name and password,
serial number, and password, serial number, MAC address, and IMEI.
Made in ThailandMade in Taiwan
Figure 3. Router label
User Manual11Hardware Setup
Orbi 5G WiFi 6 Mesh System
To Next Page
Loading...
