NETGEAR Orbi RBK22 User Manual

To change the LAN TCP/IP settings:
1.
Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2. Enter orbilogin.com.
A login window opens.
3. Enter the admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5.
In the IP Address field, type the IP address.
6.
In the IP Subnet Mask, type the subnet mask of the router.
The IP address and subnet mask identifies which addresses are local to a specific
device and which must be reached through a gateway or router.
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information
with other routers.
a. Select the RIP direction:
•
Both. The router broadcasts its routing table periodically and incorporates
information that it receives.
•
Out Only. The router broadcasts its routing table periodically.
•
In Only. The router incorporates the RIP information that it receives.
b. Select the RIP version:
•
Disabled. This is the default setting.
•
RIP-1. This format is universally supported. It is adequate for most networks,
unless you are using an unusual network setup.
•
RIP-2B. This format carries more information. RIP-2B sends the routing data
in RIP-2 format and uses subnet broadcasting.
•
RIP-2M. This format carries more information. RIP-2M sends the routing data
in RIP-2 format and uses multicasting.
8. Click the Apply button.
User Manual70Specify Network Settings
Orbi WiFi System

NETGEAR Orbi RBK22 Specifications

General

Brand	NETGEAR
Model	Orbi RBK22
Category	Network Router
Language	English