7. Power LED: For more information about the Power LED behavior, see Orbi router
LED behavior on page 10.
8. Reset button: Use the Reset button to restart (reboot) the router or reset the router
to its factory default settings:
•
Restart the router: Press the Reset button for less than five seconds. The Power
LED lights solid amber and the router restarts.
•
Reset the router to its factory default settings: Press and hold the Reset button
until the Power LED starts blinking amber. The router resets and returns to its
factory settings. For information about the factory settings, see Factory settings
on page ?.
Orbi router LED behavior
The Orbi router has an LED on the front and a Power LED on the back.
The following table describes the LED behavior for the router's Power LED.
Table 1. Power LED behavior
DescriptionLED color
Power is on.Solid green
The router is restarting.Solid amber
The router's firmware is resetting to its factory
default settings.
Blinking amber
The router's firmware is corrupted.Blinking red
Power is not supplied to the routerOff
The following table describes the LED behavior for the router LED located on the front
of the router.
Table 2. Router LED behavior
DescriptionLED color
The router is powering up or the Sync button
was pressed.
Pulsing white
The router is resetting to its factory default
settings.
Solid white
User Manual10Overview
Orbi Quad-Band Mesh WiFi 6E System
To Next Page
Loading...
Need help?
General
