NETGEAR PL1000 User Manual

10
Troubleshooting Tips
Power LED is o. Make sure that power is supplied to the electrical
outlet, and that the Powerline devices are not plugged
into an extension cord, power strip, or surge protector.
Power LED is amber. Power saving mode occurs when the Ethernet LED is
o. This can occur in the following circumstances:
• The Ethernet cable is unplugged.
• The device that is connected through the Ethernet
cable is turned o.
• The adapter is idle for 10 minutes.
It returns to normal mode within two seconds
aer the Ethernet link is established.
Pick A Plug LED is o. • If you already set network security, make sure
that all Powerline devices are using the same
encryption key; for information see the online user
manual.
• Press the Factory Reset button on each device
for one second to return the Powerline adapter to
its factory default settings
.

NETGEAR PL1000 Specifications

General

Wi-Fi	No
Power plug	-
Ethernet LAN	Yes
PowerLine standard	HomePlug AV2
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN (RJ-45) ports	1
Maximum data transfer rate	1000 Mbit/s
Maximum operating distance	500 m
Ethernet LAN interface type	Gigabit Ethernet
Power consumption (standby)	0.471 W
Quantity per pack	1 pc(s)
Antenna type	Internal
Product color	White
Shipping (inner) case net weight	6270 g
Number of layers per pallet (air)	3 pc(s)
Number of layers per pallet (sea)	5 pc(s)
Number of cartons per pallet layer	12 pc(s)
Harmonized System (HS) code	85171800
Shipping (inner) case width	458 mm
Shipping (inner) case height	400 mm
Shipping (inner) case length	197 mm
Quantity per shipping (inner) case	10 pc(s)

Weight and Dimensions

Depth	35.9 mm
Width	59 mm
Height	100 mm
Weight	126 g
Package depth	166 mm
Package width	185 mm
Package height	82 mm
Package weight	510 g