Need help?Do you have a question about the NETGEAR Powerline PLP2000 and is the answer not in the manual?
General| Model | PLP2000 |
|---|---|
| Type | Powerline Adapter |
| Powerline Speed | 2000 Mbps |
| Passthrough Power Outlet | Yes |
| HomePlug AV2 | Yes |
| Encryption | 128-bit AES |
| Operating Temperature | 0°C to 40°C |
| Operating Humidity | 10% to 90% non-condensing |
| Standards and Protocols | HomePlug AV2, IEEE 1901 |
| Ethernet Ports | 2 Gigabit Ethernet ports |
| Plug Type | US |
Describes the states of the Power LED: solid green for power on, blinking green for power saving or setup, and off for no power.
Details the Ethernet LED states: solid green for a link, off for no connection detected.
Explains the Pick A Plug LED colors (Red, Amber, Green) indicating link rate performance and 'Off' for no compatible devices found.
Details how to use the button for secure network creation or factory reset, including timing.
Describes the two GbE ports for connecting wired devices like computers, routers, or consoles.
Provides solutions for Power LED being off or slowly blinking green, often related to power supply or power saving mode.
Addresses Pick A Plug LED being off, suggesting checking encryption keys or performing a factory reset.
Offers advice for amber or red Pick A Plug LED, recommending moving adapters or unplugging interfering devices.
Suggests checking Ethernet cables and performing a factory reset if the Ethernet LED is off.
To Next Page