NETGEAR Powerline PLP2000 User Manual

10
Troubleshooting Tips
Power LED is o. Make sure that power is supplied to the electrical
outlet, and that the Powerline devices are not plugged
into an extension cord, power strip, or surge protector.
Power LED is slowly
blinking green.
Power saving mode occurs when the Ethernet LED is
o. This can occur in the following circumstances:
• The Ethernet cable is unplugged.
• The device connected through the Ethernet cable
is turned o.
• The adapter is idle for 10 minutes.
It returns to normal mode within two seconds
aer the Ethernet link is up.
Pick A Plug LED is o. • If you already set network security, make sure
that all Powerline devices are using the same
encryption key. See the online user manual for
details.
• Press and hold the Security/Factory Reset
button for 8 to 10 seconds on each device to
return the Powerline adapter to its factory default
settings
.

NETGEAR Powerline PLP2000 Specifications

General

Model	PLP2000
Type	Powerline Adapter
Powerline Speed	2000 Mbps
Passthrough Power Outlet	Yes
HomePlug AV2	Yes
Encryption	128-bit AES
Operating Temperature	0°C to 40°C
Operating Humidity	10% to 90% non-condensing
Standards and Protocols	HomePlug AV2, IEEE 1901
Ethernet Ports	2 Gigabit Ethernet ports
Plug Type	US