8
Secure Your Network
Setting security is optional, but highly recommended.
¾ To create a secure network:
1. Plug in your new adapters.
2. Wait until the Pick A Plug LEDs are lit.
3. Press the Security/Factory Reset button on one of the adapters for
two seconds, and then press the Security/Factory Reset button on
one of the other adapters in your existing network for two seconds.
You must press both buttons within two minutes.
Once secure pairing completes successfully, the power LEDs and Pick
A Plug LEDs are lit and the adapter can access the internet.
4. If you are installing additional adapters, repeat Step 3 with one of the
secure adapters and one of the adapters that is not yet secured.
Note: The Security/Factory Reset button does not work in power
saving mode (see Troubleshooting Tips on page 10).
Warning: Do not press the
Security/Factory Reset
button on the
Powerline adapter until installation is complete and the adapters are
communicating with each other (indicated by the blinking Power
LED). Pressing this button too soon can temporarily disable Powerline
communication. If this occurs, press and hold the Security/Factory
Reset button for 8 to 10 seconds to return the Powerline adapter to its
factory default settings.
To Next Page
Loading...
Need help?
General
