Configure VPN between ProSafe VPN Client Software and FVG318
The following configuration is tested with:
NETGEAR FVG318 with firmware version 1.0.41
NETGEAR ProSafe VPN Client Software version 10.5.1
Configure the FVG318
1. Log into the FVG318’s admin GUI.
2. Click on VPN Wizard on the left panel under VPN.
3. Click Next.
4. Enter a connection name and a value for the pre-shared key. The same name and
pre-shared key have to be entered when configuring the ProSafe VPN client
software. Select This VPN tunnel will connect to A remote VPN client.
To Next Page
