What to do if LAN or WAN port LEDs are not on for NETGEAR Firewall?
If the LAN or WAN port LEDs are not lit on your NETGEAR Firewall, ensure that the Ethernet cable connections are securely plugged into both the firewall and the connected hub, router, or workstation. Also, verify that the connected hub, router, or workstation is powered on. Finally, confirm that you are using the correct Ethernet cables.
Details how to configure IPv4 Internet connections and WAN settings.
Explains how to manually configure IPv4 Internet connection parameters provided by the ISP.
Details how to configure IPv6 Internet connections and WAN settings.
Explains how to use a DHCPv6 server for automatic IPv6 Internet connection configuration.
Provides instructions for configuring a static IPv6 Internet connection using ISP-provided information.
Details how to configure a PPPoE IPv6 Internet connection using ISP-provided information.
Details the process of configuring a VLAN profile, including port membership and IP settings.
Describes how to enable and configure the DMZ port for both IPv4 and IPv6 traffic.
Explains the concept of firewall rules for blocking or allowing specific traffic types.
Details how to configure outbound rules to block specific Internet services or applications.
Explains how to configure inbound rules to make local servers accessible from the Internet.
Provides steps to create and manage LAN WAN rules for traffic control.
Details how to configure the VPN firewall to protect against common network attacks.
Explains how to bind IP addresses to MAC addresses to enhance network security.
Guides users through configuring multiple gateway or client VPN tunnel policies using the IPSec VPN Wizard.
Provides steps to set up an IPv4 gateway-to-gateway VPN tunnel using the VPN Wizard.
Provides steps to set up an IPv6 gateway-to-gateway VPN tunnel using the VPN Wizard.
Guides users through setting up an IPv4 client-to-gateway VPN tunnel using the VPN Wizard.
Covers managing Internet Key Exchange (IKE) policies for VPN connections.
Details how to create, manage, edit, enable, or disable VPN policies.
Provides troubleshooting steps for issues accessing the VPN firewall's web management interface.
Offers troubleshooting steps for problems with Internet or LAN connectivity.
Explains how to reset the VPN firewall to its original factory default settings.
To Next Page
General