NETGEAR ProSAFE SRX5308 - Create an IPv4 Client-to-Gateway VPN Tunnel with the Wizard

Virtual Private Networking Using IPSec and L2TP Connections
212
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Create an IPv4 Client-to-Gateway VPN Tunnel with the
Wizard
Figure 135.
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard to Configure the Gateway for a Client Tunnel on page 212.
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection on page 215 or
Manually Create a Secure Connection Using the NETGEAR VPN Client on page 220.
Use the VPN Wizard to Configure the Gateway for a Client Tunnel
 To set up a client-to-gateway VPN tunnel using the VPN Wizard:
1. Select VPN > IPSec VPN > VPN Wizard.
In the upper right of the screen, the IPv4 radio
button is selected by default. The VPN Wizard screen displays the IPv4 settings. (The
following figure contains an example.)