NETGEAR ProSAFE SRX5308 - Page 213

Virtual Private Networking Using IPSec and L2TP Connections
213
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 136.
To display the wizard default settings, click the VPN Wizard default values option arrow
in the upper right of the screen. A pop-up screen displays (see Figure 127 on page 205),
showing the wizard default values. After you complete the wizard, you can modify these
settings for the tunnel policy that you have set up.
2. Complete the settings as described in the following table:
Table 46. IPSec VPN Wizard settings for a client-to-gateway tunnel
Setting Description
About VPN Wizard
This VPN tunnel will connect
to the following peers
Select the VPN Client radio button. The default remote FQDN (remote.com)
and the default local FQDN (local.com) display in the End Point Information
section of the screen.
Connection Name and Remote IP T
ype
What is the new Connection
Name?
Enter a descriptive name for the connection.
This name is used to help you
to manage the VPN settings; the name is not supplied to the VPN client.
What is the pre-shared key?
Enter a pre-shared key. The key needs to be entered both here and on the
remote VPN gateway, or the remote VPN client. This key needs to have a
minimum length of 8 characters and cannot exceed 49 characters.