NETGEAR ProSAFE WC9500 User Manual

Installation and Configuration Overview
95
ProSAFE Wireless Controller
 To perform the initial configuration of the wireless controller:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Configuration > System > General.
The General Settings page displays.
5. Enter a name for the wireless controller and select the country in which the wireless
controller is used.
6. Click the Apply button.
Your settings are saved.
7. Select Configuration > System > Time.
The Time Setting page displays.
8. Select the time zone in which the wireless controller is used. Optionally, configure the NTP
settings.
For more information, see Manage the Time Settings on page 101.
9. Click the Apply button.
Your settings are saved.
10. Select Configuration > System > IP/VLAN.
The IP Settings page displays.
11. Enter the IP settings for your network and the VLANs that you want to assign to the wireless
controller.
Note: A management VLAN is used for all SNMP and HTTP traffic to and
from the wireless controller and managed access points.
Note: Clear the Untagged VLAN check box only if the hubs and switches in
your network support the VLAN (802.1Q) standard. Likewise, change
the untagged VLAN value only if the hubs and switches in your network
support the VLAN (802.1Q) standard.
For more information, see Manage the IP, VLAN, and Link Aggregation Settings on
page 102.
12. Click the Apply button.

NETGEAR ProSAFE WC9500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC9500
Category	Controller
Language	English