NETGEAR R6300 Installation Guide

9
Troubleshooting
If the browser does not display the web page:
• Make sure that the PC is connected to one of the four LAN
Ethernet ports, or wirelessly to the router.
• Make sure that the router is fully up and running. Its WiFi LED
should turn on.
• Close and reopen the browser to make sure that the browser
does not cache the previous page.
• Type http://routerlogin.net.
• If the PC is set to a static or fixed IP address (this is uncommon),
change it to obtain an IP address automatically from the router.
ReadySHARE Access
After installation and set up, you can insert a USB storage device into
the USB port on the router and share the contents with other network
users. (If your USB device has special drivers, it is not compatible.)
Note: If your USB device requires a power supply, you must use it
when connecting your USB device to a NETGEAR router or gateway.
It may take up to 2 minutes before the USB drive is ready for sharing
after it is connected to the router.
To access your USB device:
On Windows systems, use any of these methods:
• Select Start > Run and enter \\readyshare in the dialog box.
Click OK.
• Open Explorer or Safari and enter \\readyshare in the address
bar.
• Open My Network Places and enter \\readyshare in the address
bar.

NETGEAR R6300 Specifications

Ports & interfaces

USB ports	2 USB 2.0 ports
Ethernet ports	5 Gigabit Ethernet ports
WAN ports	1 WAN port

System Memory

flash memory	128 MB
RAM	128 MB
memory type	flash and RAM

Weight and Dimensions

dimensions	205 x 255 x 77 mm
weight	654 g