Contents
1 Introduction•
2 Hardware Specifications•
3 Installation•
4 Upgrading/Downgrading
DD-WRT
•
5 Recovery•
6 GPIO•
7 VLAN Detached networks
7.1 Detaching the
SFP+ port
♦
•
Introduction
Hardware Specifications
See Netgear R9000 on wikidevi
This router can handle top VPN speeds, as of 2019.
Please note, Wireless-AD (60GHz) support is untested at this time, 2019.
10g interface- supported SFP hardware info:
https://forum.dd-wrt.com/phpBB2/viewtopic.php?p=1230130#1230130
Installation
Download and flash the factory-to-ddwrt.img file:
Authenticate to the router. The original Netgear firmware defaults to IP address 192.168.1.1,
username "admin" and password "password"
1.
Go to the Administration page - then Upgrade (or something similar).2.
You will see a notice about the file you uploaded being older than the firmware currently on the
router. Click Yes to proceed.
3.
The router will flash DD-WRT. Wait a few minutes (5 min to be safe).4.
Try logging into DD-WRT at http://192.168.1.1. You should see a screen asking you to create a username and
password.
Netgear_R9000
Contents 1
To Next Page
Need help?
General
