10
For information about installing disks, see the hardware manual for
your system.
3. Using a straightened paper clip, press and hold the Reset button.
4. Press the Power button.
The system powers on.
5. Continue pressing the Reset button until the system enters boot
mode:
• If you are using a 2-bay storage system, the Power, Disk 1, Disk
2, and Backup LEDs light when the system is in boot mode.
• If you are using a 4-bay or 6-bay storage system, the status
display screen indicates that the system is in boot mode.
6. Select the factory default option from the boot menu:
• If you are using a 2-bay storage system, do the following:
a. Scroll through the boot menu options by pressing the
Backup button.
b. When only the Disk 1 LED is lit, press and release the Reset
button.
• If you are using a 4-bay storage system, do the following:
a. Scroll through the boot menu options by pressing the
Backup button.
To Next Page
Loading...
