NETGEAR WN2000RPT - Set up and Enable the Access List

Manage the Extender Network and Security Settings
43
N300 WiFi Range Extender WN2000RPT
example, 00:09:AB:CD:EF:01). Typically, the MAC address is on the label of the WiFi device.
If you do not have access to the label, you can display the MAC address using the network
configuration utilities of the computer. You might also find the MAC addresses on the Network
Devices screen (see View the Wired and WiFi Network Devices on page 61).
CAUTION:
If you use a WiFi device to set up the access list, add your WiFi device to
the access list. Otherwise, you are disconnected when you click the Apply
button. To avoid this situation, use a computer with a wired connection to
access the extender.
Set Up and Enable the Access List
Before you can enable the access list, you must add the MAC addresses of the WiFi devices
that you want to grant access to the WiFi network of the extender.
 To set up and enable the access list:
1. On your computer, launch an Internet browser such as Mozilla Firefox or Microsoft
Internet Explorer
.
2. In the address field of your browser, enter http://www
.mywifiext.net.
You are prompted to enter a user name and password. If you do not see the login prompt,
make sure to include http:// when you type http://www.mywifiext.net in your browser
.
3. Type admin for the user name and type your password.
If you have not yet personalized your password, type password for the password.
4. Select Advanced > Wireless Settings
.
5. Click the Setup Access List button.