NETGEAR WNCE4004

Chapter 1. Getting Started | 5
Wireless HD Video and Gaming Adapter WNCE4004
Rear Panel
Ethernet
ports
Power
jack
Figure 1. Rear panel
Installation
The Wireless HD Video and Gaming Adapter (WNCE4004) Installation Guide, included in the
package, explains how to install your Internet adapter. The steps are summarized in this
section.
1. Y
ou use a computer to set up the Internet adapter. During setup, make sure that your
computer is not connected to a router. You can restore the connection after the Internet
adapter installation is complete.
• Disconnect the Ethernet cable from your computer if you use it for a wired network
connection.
• If your computer is wirelessly connected to a network, stop your wireless connection.
2. Connect the Internet adapter.
• Use an Ethernet cable (included) to connect the Internet adapter to your computer
.
• Use the power adapter to provide power to the Internet adapter. (See Installation on
page 5.)
3. Open your Internet browser
. It automatically displays the setup page. If the setup page is not
displayed, type http://www.mywifiext.net as the browser address. Follow the instructions
on the setup page.
4. Disconnect the Ethernet from your computer
.
5. Connect the Internet adapter
to your TV, XBox, or Blu-ray player.
6. Congratulations!
Your installation is complete. You can return your computer to its usual
setup and begin using the Internet adapter.