NETGEAR WNR2000V3 User Manual

Getting to Know Your Wireless Router 2
To prepare your router for installation:
1. Carefully peel off the protective film covering both sides of your router (see Figure 1).
2. Set up your wireless router by inserting the tabs of the stand (supplied with your router) into
the slots on the bottom of your router as shown in Figure 2. Then, remove the protective film
covering the status light panel of the router.
3. Place your router in a suitable area for installation (near an AC power outlet and accessible to
the Ethernet cables for your wired computers).
Figure 1
Figure 2
To ensure proper heat dissipation and for router stability, it is important that you
connect the stand and place your router in an upright position.

NETGEAR WNR2000V3 Specifications

General

Frequency Band	2.4 GHz
Wireless Speed	300 Mbps
LAN Ports	4 x 10/100 Mbps
WAN Port	1 x 10/100 Mbps
Antenna	2 internal antennas
Wireless Standard	802.11n
Security	WPA, WPA2, WEP
Dimensions	177 x 130 x 35 mm
Power Supply	12V/1A
Weight	270 g (0.6 lb)