N-150 2-Port Wireless Router WNR500 User Manual
Customizing Your Network Settings 4-16
v1.0, November 2011
3. Select Wireless Repeating Function under Advanced in the main menu. The Wireless
Repeater screen displays. Select the Enable Wireless Repeating Function check box and
select the Wireless Basic Station radio button.
The available settings in this screen are:
• Disable Wireless Clients Association. If checked, the wireless basic station does not transmit
any signals to clients that are directly connected to it.
• Repeater IP Address: Set the repeater’s IP address to an IP address that is different from the
Wireless basic station and other repeaters to avoid IP address conflict. NETGEAR
recommends that you set the Ip addresses of the same network segment for the wireless
basic station and repeaters.
• Repeater MAC Address 1/2/3/4. Enter the MAC address of the router that works as the
repeater for the wireless basic station.
4. Click Apply to save your settings.
Figure 4-10
Note: A wireless basic station can be configured with up to four repeaters.
To Next Page
Loading...
