NETGEAR XS728T Installation

Installation
ProSAFE Smart Managed Switch
XS728T and XS748T
XS748 T
XS728T
Configure the Switch With a Static IP
Address
If you are using static IP addresses in your network, configure the switch
IP address before connecting the switch to your network. The default IP
address of the switch is 192.168.0.239.
Note: If your network uses a DHCP server, this section does not apply. Go
directly to Connect the Switch to a Network.
1. Configure a computer with a static IP address.
2. Plug the switch into a power outlet and connect your computer to the
switch using an Ethernet cable.
3. Open a web browser and enter the IP address of your switch.
The default IP address of the switch is 192.168.0.239.
A login page displays.
4. Enter password for the password.
5. Select System > Management > IP Configuration.
6. Enter the static IP address that you want to assign to the switch.
7. Click the Apply button.
Your settings are saved.
Connect the Switch to a Network
1. Connect the computer or device to an RJ-45 network port on the
switch front panel.
Use Category 5e (Cat 5e) or higher speed Ethernet cable (Cat 6,
Cat 6a, or Cat 7) terminated with an RJ-45 connector to make
10-Gigabit connections.
Note: We recommend Cat 6a or Cat 7 cables if the cable distance is
greater than 45 m (148 ).
Package Contents
• NETGEAR ProSAFE Smart Managed Switch XS728T or XS748T
• Rubber footpads for tabletop installation
• AC power cord (localized to country of sale)
• 19-inch rack-mount kit for rack installation
• Resource CD
2. Connect the switch to your network.
3. Power on the switch.
Configure the Switch
You can configure the switch either by using a computer’s web browser or by
installing the Smart Control Center Utility on your Windows-based computer.
Web Browser Access
1. Connect the switch to your network.
2. For initial configuration, open a web browser on a computer that is on the
same network and subnet as the switch and enter the switch’s IP address.
If you are unsure how to determine the IP address of the switch, you can
use the Smart Control Center Utility.
3. Enter the password.
The default password is password.
4. Click the Login button.
5. Configure the switch for your network.
For information about switch configuration, see the soware administration
guide for your switch.

NETGEAR XS728T Specifications

General

Model	XS728T
Ports	28
10GBase-T Ports	24
SFP+ Ports	4
Switching Capacity	560 Gbps
Form Factor	Rack-mountable
Layer	Layer 3
Management	Yes
Weight	18.5 lbs
Total Number of Network Ports	28
Uplink Port	Yes
Ethernet Technology	10 Gigabit Ethernet
Number of Total Expansion Slots	4
Number of SFP+ Slots	4
Manageable	Yes
Width	440 mm
Forwarding Rate	417 Mpps
Power Supply	Internal
MAC Address Table Size	32K
Jumbo Frame Support	Yes
Humidity	10% to 90% non-condensing
Product Type	Switch
Media Type Supported	Twisted Pair, Optical Fiber
Layer Supported	Layer 3
Power Source	AC
Height	43.2 mm
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 70°C
Latency (10G)	1.5 μs