Need help?Do you have a question about the NETGEAR 7300 Series and is the answer not in the manual?
General| Model | NETGEAR 7300 Series |
|---|---|
| Form Factor | Rack-mountable |
| VLAN Support | Yes |
| Jumbo Frame Support | 9KB |
| Management | Web-based, CLI |
| Layer | Layer 2/3 |
Details the initial setup procedure using a direct console connection and terminal emulation.
Provides step-by-step instructions for accessing the switch via its web interface.
Provides initial steps for setting up and accessing the switch via CLI.
Details commands for viewing software version and physical port data.
Explains how to view network configurations and set IP parameters.
Explains how to clear configurations and reset the switch to factory defaults.
Details commands for viewing system information, statistics, and hardware details.
Includes commands for managing switch settings like bridge aging time and MTU.
Provides commands for managing user accounts, passwords, and session settings.
Details commands for configuring security settings like authentication and dot1x.
Configures IP addresses and subnet masks on interfaces.
Enables or disables OSPF on router interfaces.
Configures static routes, including default routes and route distances.
Displays pertinent IP interface information, including address and status.
Displays information relevant to the OSPF router configuration.
Displays the entire IP route table, including best routes and preferences.
Details DiffServ class definition, including traffic classification and service levels.
Covers commands for creating, deleting, and associating traffic classes with QoS policies.
Covers commands for creating and deleting Access Control Lists (ACLs).
Commands for configuring DHCP server parameters, address pools, and client settings.
Displays DHCP server address bindings and statistics.
Details CLI commands for managing the Power-over-Ethernet (PoE) function on the switch.
To Next Page