NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-59
202-10009-01_060204
ip vrrp ip
This command sets the ipaddress value for a virtual router. The value for <ipaddr> is the IP
Address which is to be configured on that interface for VRRP. The parameter <vrID> is the virtual
router ID which has an integer value range from 1 to 255.
Default There is no default value for ipaddress.
Format
ip vrrp <vrID> ip <ipaddr>
Mode Interface Config
ip vrrp preempt
This command sets the preemption mode value for the virtual router configured on a specified
interface. The parameter <vrID> is the virtual router ID which has an integer value range from 1 to
255
Default Enabled
Format
ip vrrp <vrID> preempt
Mode Interface Config
no ip vrrp preempt
This command sets the default preemption mode value for the virtual router configured on a
specified interface.
Default Enabled
Format
no ip vrrp <vrID> preempt
Mode Interface Config
ip vrrp priority
This command sets the priority value for the virtual router configured on a specified interface. The
priority of the interface is a priority integer from 1 to 254. The parameter <vrID> is the virtual
router ID which has an integer value ranges from 1 to 255.
Default 100
Format
ip vrrp <vrID> priority <1-254>
Mode Interface Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3