NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-104 Switching Commands
202-10009-01_060204
Format radius server retransmit <retries>
Mode Global Config
no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, when no
response is received from the RADIUS server, to the default value, i.e. 10.
Format
no radius server retransmit
Mode Global Config
radius server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted to
the RADIUS server if no response is received. The timeout value is an integer in the range of 1 to
30.
Default 6
Format radius server timeout <seconds>
Mode Global Config
no radius server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted to
the RADIUS server if no response is received, to the default value, i.e. 6.
Format no radius server timeout
Mode
Global Config
show accounting
This command is used to display the configured RADIUS accounting mode, accounting server and
the statistics for the configured accounting server.
Format show accounting [statistics <ipaddr>]
Mode Privileged EXEC
If the optional token 'statistics <ipaddr>' is not included, then only the accounting mode and the
RADIUS accounting server details are displayed.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3