User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-110 Switching Commands
202-10009-01_060204
Primary Server IP Address Indicates the configured server currently in use for authenti-
cation
Number of configured servers The configured IP address of the authentication server
Max number of retransmits The configured value of the maximum number of times a
request packet is retransmitted
Timeout Duration The configured timeout value, in seconds, for request re-trans-
missions
Accounting Mode Yes or No
If the optional token 'servers' is included, the following information regarding the configured
RADIUS servers is displayed.
IP Address IP Address of the configured RADIUS server
Port The port in use by this server
Type Primary or secondary
Secret Configured Yes / No
show radius statistics
This command is used to display the statistics for RADIUS or configured server. To show the
confifured RADIUS server statistic, the IP Address specified must match that of a previously
configured RADIUS server. On execution, the following fields are displayed.
Format show radius statistics [ipaddr]
Mode Privileged EXEC
If ip address is not specified than only Invalis Server Address filed is displayed. Otherwise other
listed fields are displayed.
Invalid Server Addresses The number of RADIUS Access-Response packets received
from unknown addresses.
Server IP Address
Round Trip Time The time interval, in hundredths of a second, between the most
recent Access-Reply/Access-Challenge and the Access-Request
that matched it from the RADIUS authentication server.
Access Requests The number of RADIUS Access-Request packets sent to this
server. This number does not include retransmissions.
To Next Page
Loading...
Need help?
General
