User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-97
202-10009-01_060204
dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port
security. The <user> parameter must be a configured user and the <listname> parameter must be a
configured authentication login list.
Format dot1x login <user> <listname>
Mode Global Config
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <count>
value must be in the range 1 - 10.
Default 2
Format dot1x max-req <count>
Mode
Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant to the default
value, i.e. 2.
Format no dot1x max-req
Mode
Interface Config
dot1x port-control
This command sets the authentication mode to be used on the specified port. . The control mode
may be one of the following.
• force-unauthorized: The authenticator PAE unconditionally sets the controlled port to
unauthorized.
• force-authorized: The authenticator PAE unconditionally sets the controlled port to
authorized.
• auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the
authentication exchanges between the supplicant, authenticator and the authentication server.
To Next Page
Loading...
Need help?
General
