NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
DHCP Server Commands 12-3
202-10009-01_060204
hardware-address
This command specifies the hardware address of a DHCP client.
Hardware-address is the MAC address of the hardware platform of the client consisting of 6 bytes
in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default Ethernet
Format hardware-address <hardwareaddress> [type]
Mode DHCP Pool Config Mode
no hardware-address
This command removes the hardware address of the DHCP client.
Format no hardware-address
Mode DHCP Pool Config Mode
host
This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32
Default None
Format host <address> [mask | prefix-length]
Mode DHCP Pool Config Mode
no host
This command removes the IP address of the DHCP client.
Format no host
Mode DHCP Pool Config Mode

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3