User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-3
202-10009-01_060204
area nssa default-info-originate
This command configures the metric value and type for the default route advertised into the
NSSA. The optional metric parameterspecifieds the metric of the default route and is to be in a
range of 1-16777215. If no metric is specified, the default valueis ****. The metric type can be
comparable (nssa-external 1) or non-comparable (nssa-external 2).
Format
area <areaid> nssa default-info-originate [<metric>]
[{comparable | non-comparable}]
Mode Router OSPF Config
area nssa no-redistribute (OSPF)
This command configures the NSSA ABR so that learned external routes will not be redistributed
to the NSSA.
Format
area <areaid> nssa no-redistribute
Mode Router OSPF Config
area nssa no-summary (OSPF)
This command configures the NSSA so that summary LSAs are not advertised into the NSSA
Format
area <areaid> nssa no-summary
Mode Router OSPF Config
area nssa translator-role (OSPF)
This command configures the translator role of the NSSA. A value of always will cause the router
to assume the role of the translator the instant it becomes a border router and a value of candidate
will cause the router to participate in the translator election process when it attains border router
status
Format
area <areaid> nssa translator-role {always | candi-
date}
Mode Router OSPF Config
To Next Page
Loading...
Need help?
General
