NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-36 Switching Commands
202-10009-01_060204
ip http secure-protocol
This command is used to set protocol levels (versions). The protocol level can be set to TLS1,
SSL3 or to both TLS1 and SSL3.
Default SSL3 and TLS1
Format
ip http secure-protocol [SSL3] [TLS1]
Mode Privileged EXEC
no ip http secure-protocol
This command is used to remove protocol levels (versions) for secure HTTP.
Format
no ip http secure-protocol [SSL3] [TLS1]
Mode Privileged EXEC
ip http secure-server
This command is used to enable the secure socket layer for secure HTTP.
Default Disabled
Format
ip http secure-server
Mode Privileged EXEC
no ip http secure-server
This command is used to disable the secure socket layer for secure HTTP.
Format
ip http secure-server
Mode Privileged EXEC
ip http server
This command enables access to the switch through the Web interface. When access is enabled,
the user can login to the switch from the Web interface. When access is disabled, the user cannot
login to the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are effected.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3