NETGEAR 7300 Series

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-28 Routing Commands
202-10009-01_060204
ip ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface.
The value for <seconds> is the number of seconds between link-state advertisement
retransmissions for adjacencies belonging to this router interface. This value is also used when
retransmitting database desctions and link-state request packets.
Valid values range from 0 to 3600 (1 hour).
Default 5
Format
ip ospf retransmit-interval <0-3600>
Mode Interface Config
no ip ospf retransmit-interval
This command sets the default OSPF retransmit Interval for the specified interface.
Format
no ip ospf retransmit-interval
Mode Interface Config
ip ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. In addition, it sets the
estimated number of seconds it takes to transmit a link state update packet over this interface.
Valid values for <seconds> range from 1 to 3600 (1 hour).
Default 1
Format
ip ospf transmit-delay <1-3600>
Mode Interface Config
no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
Format
no ip ospf transmit-delay
Mode Interface Config