User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
10-16 CLI Commands: Differentiated Services
202-10009-01_060204
The service commands attach a defined policy to a directional interface. Only one policy may be
assigned at any one time to an interface in a particular direction. The policy type (in, out) must
match the interface direction to which it is attached.
This set of commands consists of service addition/removal.
The CLI command root is
service-policy
service-policy
This command attaches a policy to an interface in a particular direction. The command can be used
in the Interface Config mode to attach a policy to a specific interface. Alternatively, the command
can be used in the Global Config mode to attach this policy to all system interfaces. The direction
value is either in or out. The <
policyname> parameter is the name of an existing DiffServ policy,
whose type must match the interface direction. Note that this command causes a service to create a
reference to the policy.
Note: This command effectively enables DiffServ on an interface (in a particular direction). There
is no separate interface administrative 'mode' command for DiffServ.
Note: This command shall fail if any attributes within the policy definition exceed the capabilities
of the interface. Once a policy is successfully attached to an interface, any attempt to change the
policy definition such that it would result in a violation of said interface capabilities shall cause the
policy change attempt to fail.
Format
service-policy {in | out} <policymapname>
Mode Global Config (for all system interfaces)
Mode Interface Config (for a specific interface)
Restrictions Only a single policy may be attached to a particular interface in a
particular direction at any one time.
no service-policy
This command detaches a policy from an interface in a particular direction. The command can be
used in the Interface Config mode to detach a policy from a specific interface. Alternatively, the
command can be used in the Global Config mode to detach this policy from all system interfaces
to which it is currently attached. The direction value is either in or out. The <
policyname>
parameter is the name of an existing DiffServ policy. Note that this command causes a service to
remove its reference to the policy.
Note: This command effectively disables DiffServ on an interface (in a particular direction).
There is no separate interface administrative 'mode' command for DiffServ.
To Next Page
Loading...
Need help?
General
