User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-49
202-10009-01_060204
RIP Admin Mode RIP administrative mode of router RIP operation; enable acti-
vates and disable de-activates the RIP ability for the switch. This
is a configured value.
Global Route Changes The number of route changes made by RIP to the IP Route Data-
base.
Global queries
The number of responses sent to RIP queries from other systems.
Default-metric Source protocol/routes that are being redistributed.
Source Source protocol/routes that are being redistributed.
Metric-value Metric of the routes being redistributed.
Match-value The criteria by which OSPF routes are redistributed into other
routing domains.
Distribute-list TAccess list used to filter redistributed routes.
Default-info originate Indicates whether the default routes received from other source
protocols are advertised or not
show ip rip interface brief
This command displays general information for each RIP interface. For this command to display
successful results routing must be enable per interface (i.e. config router rip interface <slot/port>
enable).
Format
show ip rip interface brief
Mode Privileged EXEC and User EXEC
Slot/Port Is the unit slot/port identifying each interface.
IP Address The IP source address used by the specified RIP interface.
Send Version The RIP version(s) used when sending updates on the specified
interface. The types are none, RIP-1, RIP-1c, RIP-2.
Receive Version The RIP version(s) allowed when receiving updates from the
specified interface. The types are none, RIP-1, RIP-2, Both
RIP Mode RIP administrative mode of router RIP operation; enable acti-
vates, disable de-activates it.
Link State The mode of the interface (up or down).
To Next Page
Loading...
Need help?
General
