User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-65
202-10009-01_060204
show vlan port
This command displays VLAN port information.
Format
show vlan port {<slot/port> | all}
Mode Privileged EXEC and User EXEC
slot/port Indicates by slot id and port number which port is controlled by
the fields on this line. It is possible to set the parameters for all
ports by using the selectors on the top line.
Port VLAN ID The VLAN ID that this port will assign to untagged frames or pri-
ority tagged frames received on this port. The value must be for
an existing VLAN. The factory default is 1.
Acceptable Frame Types Specifies the types of frames that may be received on this port.
The options are 'VLAN only' and 'Admit All'. When set to
'VLAN only', untagged frames or priority tagged frames received
on this port are discarded. When set to 'Admit All', untagged
frames or priority tagged frames received on this port are
accepted and assigned the value of the Port VLAN ID for this
port. With either option, VLAN tagged frames are forwarded in
accordance to the 802.1Q VLAN specification.
Ingress Filtering May be enabled or disabled. When enabled, the frame is dis-
carded if this port is not a member of the VLAN with which this
frame is associated. In a tagged frame, the VLAN is identified by
the VLAN ID in the tag. In an untagged frame, the VLAN is the
Port VLAN ID specified for the port that received this frame.
When disabled, all frames are forwarded in accordance with the
802.1Q VLAN bridge specification. The factory default is dis-
abled.
GVRP
May May be enabled or disabled.
Default Priority The 802.1p priority assigned to tagged packets arriving on the
port.
shutdown
This command disables a port.
Default
Enabled
Format shutdown
To Next Page
Loading...
Need help?
General
