User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-50 Routing Commands
202-10009-01_060204
show ip route
This command causes the entire route table to be displayed. This commands takes no options.
Format
show ip route
Mode Privileged EXEC and User EXEC
Network Address Is an IP address identifying the network on the specified inter-
face.
Subnet Mask Is a mask of the network and host portion of the IP address for the
router interface.
Protocol Tells which protocol added the specified route. The possibilities
are: local, static, OSPF or RIP.
Next Hop Intf The outgoing router interface to use when forwarding traffic to
the next destination.
Next Hop IP Address The outgoing router IP address to use when forwarding traffic to
the next router (if any) in the path toward the destination.
Total Number of Routes The total number of routes.
show ip route bestroutes
This command causes the entire route table to be displayed. This commands takes no options.
Format
show ip route bestroutes
Mode Privileged EXEC and User EXEC
Network Address Is an IP route prefix for the destination.
Subnet Mask Is a mask of the network and host portion of the IP address for the
specified interface.
Protocol Tells which protocol added the specified route. The possibilities
are: local, static, OSPF or RIP.
Next Hop Intf The outgoing router interface to use when forwarding traffic to
the next destination.
Next Hop IP Address The outgoing router IP address to use when forwarding traffic to
the next router (if any) in the path toward the destination. The
next router will always be one of the adjacent neighbors or the IP
address of the local interface for a directly attached network.
Total Number of Routes The total number of routes in the route table.
To Next Page
Loading...
Need help?
General
