NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-13
202-10009-01_060204
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the
system. The <hops> parameter has a range of 1 to 16.
Default 4
Format
bootpdhcprelay maxhopcount <1-16>
Mode Global Config
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP
Relay on the system.
Format
no bootpdhcprelay maxhopcount
Mode Global Config
bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the
system. When the BOOTP relay agent receives a BOOTREQUEST message, it MAY use the
seconds-since-client-began-booting field of the request as a factor in deciding whether to relay the
request or not. The parameter has a range of 0 to 100 seconds.
Default 0
Format
bootpdhcprelay minwaittime <0-100>
Mode Global Config
no bootpdhcprelay minwaittime
This command configures the default minimum wait time in seconds for BootP/DHCP Relay on
the system.
Format
no bootpdhcprelay minwaittime
Mode Global Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3