NETGEAR 7300 Series

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-2 Routing Commands
202-10009-01_060204
area authentication
This command specifies the authentication type to be used for the specified area id.
Default
none
Format area <areaid> authentication {none | simple | encrypt}
Mode Router OSPF Config
no area authentication
This command sets the default authentication type to be used for the specified area id.
Format
no area <areaid> authentication
Mode Router OSPF Config
area default-cost
This command configures the monetary default cost for the stub area. The operator must specify
the area id and an integer value between 1-16777215.
Format
area <areaid> default-cost <1-16777215>
Mode Router OSPF Config
area nssa
This command configures the specified areaid to function as an NSSA.
Format
area <areaid> nssa
Mode Router OSPF Config
no area nssa
This command disables nssa from the specified area id.
Format
no area <areaid> nssa
Mode Router OSPF Config