NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
6-2 Quick Start up
202-10009-01_060204
System Info and System Setup
Quick Start up Software Version Information
Quick Start up Physical Port Data
Table 6-1. Quick Start up Software Version Information
Command Details
show hardware
(in Privileged EXEC)
Allows the user to see the software version the device contains
System Description - The switch's model name
Burned in MAC address - the MAC address assigned to this
switch CPU
Software version - software release of this switch
Table 6-2. Quick Start up Physical Port Data
Command Details
show port all
(in Privileged EXEC)
Displays the Ports
slot/port
Type - Indicates if the port is a special type of port
Admin Mode - Selects the Port Control Administration State
Physical Mode - Selects the desired port speed and duplex mode
Physical Status - Indicates the port speed and duplex mode
Link Status - Indicates whether the link is up or down
Link Trap - Determines whether or not to send a trap when link status
changes
LACP Mode - Displays whether LACP is enabled or disabled on this
port.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3