NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-75
202-10009-01_060204
vlan port pvid all
This command changes the VLAN ID for all interface.
Default
1
Format vlan port pvid all <1-4094>
Mode Global Config
no vlan port pvid all
This command sets the VLAN ID for all interfaces to 1.
Format
no vlan port pvid all <1-4094>
Mode Global Config
vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to enabled. If tagging
is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as
untagged frames. The ID is a valid VLAN identification number.
Format
vlan port tagging all <1-4094>
Mode Global Config
no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging
is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
Format
no vlan port tagging all <1-4094>
Mode Global Config
vlan protocol group
This command adds protocol-based VLAN group to the system. The <groupName> is a character string of 1 to 16
characters. When it is created, the protocol group will be assigned a unique number that will be used to identify the
group in subsequent commands.
Format vlan protocol group <groupname>

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3