User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-44 Switching Commands
202-10009-01_060204
protocol vlan group
This command adds the physical <slot/port> interface to the protocol-based VLAN identified by
<groupid>. A group may have more than one interface associated with it. Each interface and
protocol combination can only be associated with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command will fail and
the interface(s) will not be added to the group.
Default
none
Format protocol vlan group <groupid>
Mode Interface Config
no protocol vlan group
This command removes the <interface> from this protocol-based VLAN group that is identified
by this <groupid>. If <all> is selected, all ports will be removed from this protocol group.
Format
no protocol vlan group <groupid>
Mode Interface Config
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by <groupid>.
A group may have more than one interface associated with it. Each interface and protocol
combination can only be associated with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command will fail and the
interface(s) will not be added to the group.
Default
none
Format protocol vlan group all <groupid>
Mode Global Config
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by
this <groupid>.
Format
no protocol vlan group all <groupid>
Mode Global Config
To Next Page
Loading...
Need help?
General
