User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-18 Switching Commands
202-10009-01_060204
Static Capability This field displays whether or not the device has static capability
enabled.
For each port-channel the following information is displayed:
Name This field displays the name of the port-channel.
Link State This field indicates whether the link is up or down.
Mbr Ports This field lists the ports that are members of this port-channel, in
slot/port notation.
Active Ports This field lists the ports that are actively participating in this port-
channel.
.
Management Commands
These commands manage the switch and show current management settings.
bridge aging-time
This command configures the forwarding database address aging timeout in seconds. In an IVL
system, the [fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
Default 300
Format
bridge aging-time <10-1,000,000> [fdbid | all]
Mode Global Config
Seconds The <seconds> parameter must be within the range of 10 to
1,000,000 seconds.
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to con-
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
no bridge aging-time
This command sets the forwarding database address aging timeout to 300 seconds. In an IVL
system, the [fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
To Next Page
Loading...
Need help?
General
