User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Web-Based Management Interface 4-7
202-10009-01_060204
• Smart Wizard
Secondary Menus
The Secondary Menus under the Main Menu contain a host of options that you can use to
configure your switch. The online help contains a detailed description of the features on each
screen. You can click the ‘help’ or the question mark at the top right of each screen to view the
help menu topics.
The Secondary Menus are detailed below, with cross-references to the sections in this manual that
contain the corresponding command descriptions.
Management
• System — see “System Information and Statistics Commands” on page 8-1
• Utilities — see “System Utilities” on page 8-112
• Access — see the following sections:
• “Administration Console Telnet Interface” on page 3-1
• “Management Commands” on page 8-18
• Security — see “Security Commands” on page 8-95 and “User Account Management
Commands” on page 8-90
• Port Access Control — “show dot1x” on page 8-106
• RADIUS — see “show radius statistics” on page 8-110
• PoE — see “FSM7326P Power Over Ethernet Commands” on page 13-1
Switch
• Port — see “show port” on page 8-61
• MAC Addresses — see “System Information and Statistics Commands” on page 8-1
• Spanning Tree — see “Spanning Tree Commands” on page 8-77
• Link Aggregation — see “Device Configuration Commands” on page 8-38
• VLAN — see “show vlan” on page 8-63
• Mcast Fwding DB — see “show forwardingdb agetime” on page 8-23
To Next Page
Loading...
Need help?
General
