NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-27
202-10009-01_060204
ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface.
The value for <seconds> is a valid positive integer, which represents the length of time in seconds.
The value for the length of time must be the same for all routers attached to a network.
Valid values range from 1 to 65535.
Default 10
Format
ip ospf hello-interval <1-65535>
Mode Interface Config
no ip ospf hello-interval
This command sets the default OSPF hello interval for the specified interface.
Format
no ip ospf hello-interval
Mode Interface Config
ip ospf priority
This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255.
A value of '0' indicates that the router is not eligible to become the designated router on this
network.
Default 1, which is the highest router priority.
Format
ip ospf priority <0-255>
Mode Interface Config
no ip ospf priority
This command sets thedefault OSPF priority for the specified router interface.
Format
no ip ospf priority
Mode Interface Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3