NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-16 Routing Commands
202-10009-01_060204
Format no default-metric
Mode Router RIP Config
enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
Default Enabled
Format
enable
Mode Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode Router OSPF Config
enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
Default Enabled
Format
enable
Mode Router RIP Config
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format
no enable
Mode Router RIP Config
distance ospf
This command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF can be intra, inter, type-1,
or type-2. The OSPF specification (RFC 2328) requires that preferences must be given to the
routes learned via OSPF in the following order: intra < inter < type-1 < type-2.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3