NETGEAR 7300 Series

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
12-2 DHCP Server Commands
202-10009-01_060204
Format no client-name
Mode DHCP Pool Config Mode
default-router
This command specifies the default router list for a DHCP client. {address1, address2… address8}
are valid IP addresses, each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
Default None
Format default-router <address1> [<address2>....<address8>]
Mode DHCP Pool Config
no default-router
This command removes the default router list.
Format no default-router
Mode DHCP Pool Config
dns-server
This command specifies the IP servers available to a DHCP client. address1, address2… address8
are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
Default None
Format dns-server <address1> [<address2>....<address8>]
Mode DHCP Pool Config Mode
no dns-server
This command removes the DNS Server list.
Format no dns-server
Mode DHCP Pool Config Mode