User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-68 Switching Commands
202-10009-01_060204
spanning-tree bpdumigrationcheck
This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
Format
spanning-tree bpdumigrationcheck {<slot/port> | all}
Mode Global Config
no spanning-tree bpdumigrationcheck
This command disables BPDU migration check on a given interface. The all option disables
BPDU migration check on all interfaces.
Format
no spanning-tree bpdumigrationcheck {<slot/port> |
all}
Mode Global Config
speed
This command sets the speed and duplex setting for the interface.
Format
speed {{100 | 10} {half-duplex | full-duplex} | 1000
full-duplex}
Mode
Interface Config
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 100BASE-T full duplex
speed all
This command sets the speed and duplex setting for all interfaces.
Format
speed all {{100 | 10} {half-duplex | full-duplex} |
1000 full-duplex}
To Next Page
Loading...
Need help?
General
