User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-52 Switching Commands
202-10009-01_060204
set igmp groupmembershipinterval
This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.
Default 260 seconds
Format
set igmp groupmembershipinterval <1-3600>
Mode Global Config
no set igmp groupmembershipinterval
This command sets the IGMP Group Membership Interval time on the system to 260 seconds.
Format
no set igmp groupmembershipinterval
Mode Global Config
set igmp interfacemode all
This command enables IGMP Snooping on all interfaces. If an interface which has IGMP
Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will
subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed
from an interface that has IGMP Snooping enabled.
Default Disabled
Format
set igmp interfacemode all
Mode Global Config
no set igmp interfacemode all
This command disables IGMP Snooping on all interfaces.
Format
no set igmp interfacemode all
Mode Global Config
To Next Page
Loading...
Need help?
General
