User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-41
202-10009-01_060204
New LSAs Originated The number of new link-state advertisements that have been orig-
inated.
LSAs Received The number of link-state advertisements received determined to
be new instantiations.
External LSDB Limit The maximum number of non-default AS-external-LSAs entries
that can be stored in the link-state database.
show ip ospf area
This command displays information about the area. The <areaid> identifies the OSPF area that is
being displayed.
Format
show ip ospf area <areaid>
Mode Privileged EXEC and User EXEC
AreaID Is the area id of the requested OSPF area.
Aging Interval Is a number representing the aging interval for this area.
External Routing Is a number representing the external routing capabilities for this
area.
Authentication Type
Is the configured authentication type to use for this area.
Spf Runs Is the number of times that the intra-area route table has been cal-
culated using this area's link-state database.
Area Border Router Count The total number of area border routers reachable within this
area.
Area LSA Count Total number of link-state advertisements in this area's link-state
database, excluding AS External LSA's.
Area LSA Checksum A number representing the Area LSA Checksum for the specified
AreaID excluding the external (LS type 5) link-state advertise-
ments.
Stub Mode Represents whether the specified Area is a stub area or not. The
possible values are enabled and disabled. This is a configured
value.
Import Summary LSAs
Metric Value Is a number representing the Metric Value for the specified area.
Metric Type Is the Default Metric Type for the specified Area.
To Next Page
Loading...
Need help?
General
