User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-38 Switching Commands
202-10009-01_060204
no ip ssh
This command is used to disable SSH.
Format
no ip ssh
Mode Privileged EXEC
ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default 1 and 2
Format
ip ssh protocol [1] [2]
Mode Privileged EXEC
show ip ssh
This command displays the ssh settings.
Format
show ip ssh
Mode Privileged EXEC
Administrative Mode This field indicates whether the administrative mode of SSH is
enabled or disabled.
Protocol Level The protocol level may have the values of version 1, version 2 or
both versions 1 and version 2.
Connections This field specifies the current ssh connections.
Device Configuration Commands
addport
This command adds one port to the port-channel (LAG). The first interface is a logical slot and
port number of a configured port-channel.
Note: Before adding a port to a port-channel, set the physical mode of the port. See ‘speed’
command.
To Next Page
Loading...
Need help?
General
